Naslov
Design and Improvement of High Pressure Die Casting Process based on NovaFlow&Solid Software

Autori
Ivana Dumanić, Sonja Jozić, Deni Dumanić, Luka Nimac

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
International conference “Mechanical Technologies and Structural Materials” Split, MTSM 2021 / - , 2021, 29-35

Skup
10th International conference “Mechanical Technologies and Structural Materials” Split, MTSM 2021

Mjesto i datum
Split, Hrvatska, 23.09.2021. - 24.09.2021

Vrsta sudjelovanja
Poster

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
HPDC, NovaFlow&Solid, Taguchi method, Grey relational analysis, Multi-objective optimization

Sažetak
In the present paper, investigation of the temperature of the molten metal, mould temperature, plunger velocity at the 2nd phase and pressure on shrinkage of the material and total casting time is presented. Simulation of the high pressure die casting process was observed. Therefore, the investigation of this casting process was based on simulation software NovaFlow&Solid. In addition, Taguchi based orthogonal array is adopted to set design of experiment. Grey relational analysis is used to identify the optimal process parameters. The optimal levels of the controllable parameters were the temperature of the molten metal of 640 °C, mould temperature of 150 °C, 2nd phase velocity of 2.5 m/s and pressure of 10 MPa.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA