Naslov
Conceptual Mould Design for Injection Moulding of Thermoplastics

Autori
Godec, Damir ; Čatić, Igor ; Šercer, Mladen

Vrsta, podvrsta i kategorija rada
Sažeci sa skupova, cjeloviti rad (in extenso), pregledni

Skup
4th International Conference PLASTKO 2003

Mjesto i datum
Zlín, Češka Republika, 11.06.2003. - 13.06.2003

Vrsta sudjelovanja
Poster

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
Injection Moulding; Conceptual Mould Design; Decision-making Diagrams; Mould Morphological Matrix

Sažetak
Mould design for injection moulding of thermoplastic melts is becoming a more complex and complicated task, where even experienced mould designers could have problems. One of the most important phases of mould design is conceptual mould design, thus mould designer must pay special attention to this phase. The approach to this mould design phase is usually based on the designer's experience which can lead to some raw mould design faults, and which are later very difficult to correct. One of the possible solutions for this problem is application of morphological mould matrix and decision-making diagrams, which can guide to the solution for certain partial mould functions. Decision diagrams are especially important for young and less experienced mould designers, because with their application, mould design faults can be avoided in an early phase of mould development.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA