Pregled bibliografske jedinice broj: 1136734
Development of Geodetic Linear Scales Calibration Method – Initial Works and Tests
Development of Geodetic Linear Scales Calibration Method – Initial Works and Tests // 4th INTERNATIONAL DOCTORAL SEMINAR ON GEODESY GEOINFORMATICS AND GEOSPACE - PhD-Days @ geof.unizg.hr 2020
Zagreb, Hrvatska, 2020. (predavanje, nije recenziran, neobjavljeni rad, ostalo)
CROSBI ID: 1136734 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Development of Geodetic Linear Scales Calibration
Method – Initial Works and Tests
Autori
Baričević, Sergej
Vrsta, podvrsta i kategorija rada
Sažeci sa skupova, neobjavljeni rad, ostalo
Skup
4th INTERNATIONAL DOCTORAL SEMINAR ON GEODESY GEOINFORMATICS AND GEOSPACE - PhD-Days @ geof.unizg.hr 2020
Mjesto i datum
Zagreb, Hrvatska, 10.12.2020. - 11.12.2020
Vrsta sudjelovanja
Predavanje
Vrsta recenzije
Nije recenziran
Ključne riječi
geodetic linear scales ; levelling staff ; calibration ; CCD camera ; linear encoder
Sažetak
Comparator for calibration of geodetic linear scales such as levelling staffs or measuring tapes is a device that compares nominal (reference) graduation values with measured distances of graduations from zero point. Calibration is conducted to determine the actual behavior model of tested linear scale graduation. Comparators are not mass-produced and therefore are not commercially available. They must be individually designed according to the requirements of individual calibration, test, or research laboratory. Such comparator was constructed in 2002 as a part of the doctoral dissertation of prof. Đuro Barković, PhD, at the Laboratory for Measurements and Measuring Technique of the Faculty of Geodesy, University of Zagreb. Constructed comparator calibration works on the principle of distance measurement by using a linear encoder, and individual graduation lines on a geodetic linear scale are observed manually by aiming each edge of each graduation using an optical microscope. Aim of this doctoral thesis is to develop fully automated geodetic linear scales calibration method that will have uncertainty lower than 5 μm/m. It will be accomplished by updating existing comparator with a CCD camera on a servomotor driven cart. The whole calibration process will be supervised by a software developed in an open-source environment. In this paper performed works on hardware update and software development will be presented, also with initial testing and results.
Izvorni jezik
Engleski
Znanstvena područja
Geodezija
