Naslov
Influence of Centricity of Force-Proving Instrument on Calibration Results

Autori
Ćorić, Danko ; Meštrović, Krešimir ; Rodinger, Tomislav ; Šolić, Sanja

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), stručni

Izvornik
Book of Abstracts and Conference Proceedings on USB of 21th International Conference on Materials, Tribology and Recycling - MATRIB 2021 / Ćorić, Danko ; Šolić, Sanja ; Ivušić, Franjo - Zagreb : Hrvatsko društvo za materijale i tribologiju (HDMT), 2021, 161-170

Skup
21th International Conference on Materials (MATRIB 2021)

Mjesto i datum
Vela Luka, Hrvatska, 30.06.2021. - 02.07.2021

Vrsta sudjelovanja
Poster

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
Calibration ; force-proving instrument ; repeatability ; reproducibility ; hysteresis

Sažetak
For a valid measurement of the transferable force transducer, its correct positioning on the reference standard is important. In the article, the measurement of the portable Z4A/100 kN force transducer was carried out at different distances from the axial axis of the load (0 mm, 20 mm, 40 mm, 60 mm). The measurement results were processed and analyzed, from which it is evident that the values of the characteristic errors increase by moving away from the axial axis. This primarily refers to the reproducibility error, which increases by approximately 0.04% at all measurement points, and to a lesser extent to the reversibility error, for which an increase of 0.02% was recorded at lower force values.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA