Naslov
Piroliza plastičnog otpada
(Pyrolysis of plastic wastes)

Autori
Markić, Marinko ; Matijašec, Dora ; Sigurnjak, Marija ; Prevarić, Viktorija ; Miloloža, Martina ; Cvetnić, Matija ; Bolanča, Tomislav ; Ukić, Šime ; Kučić Grgić, Dajana

Vrsta, podvrsta i kategorija rada
Sažeci sa skupova, sažetak, ostalo

Izvornik
18. Ružičkini dani Danas znanost - sutra industrija / Jukić, Ante - Zagreb : Osijek : Hrvatsko društvo kemijskih inženjera i tehnologa (HDKI) ; Prehrambeno tehnološki fakultet Sveučilišta Josipa Jurja Strossmayera u Osijeku, 2020, 150-150

ISBN
978-953-6894-75-8

Skup
18. Ružičkini dani "Danas znanost - sutra industrija"

Mjesto i datum
Vukovar, Hrvatska, 16.09.2020. - 18.09.2020

Vrsta sudjelovanja
Poster

Vrsta recenzije
Domaća recenzija

Ključne riječi
piroliza ; plastični otpad ; ključni procesni parametri
(pyrolysis ; plastic waste ; key process parameters)

Sažetak
The continuous demand of plastics caused the plastic wastes accumulation in the landfill consumed a lot of spaces that contributed to the environmental problem. Some alternatives that have been developed to manage plastic wastes were recycling and energy recovery method. However, the main drawback of the recycling method is high labor cost for the separation process and water contamination that reduced the process sustainability. Due to these drawbacks, the researchers have diverted their attentions to the energy recovery method to compensate the high energy demand. As petroleum was the main source of plastic manufacturing, the recovery of plastic to liquid oil through pyrolysis process had a great potential. Pyrolysis is one of the tertiary recycling techniques in which plastic polymers are broken down into smaller organic molecules (monomers) in the absence of oxygen at elevated temperatures (>400 °C). Use of catalysts such as aluminum oxides, natural and synthetic zeolites, fly ash, calcium hydroxide, and red mud can improve the yield and quality of liquid oil. Plastic products consist mainly of polyethylene (PE), polystyrene (PS), polypropylene (PP) and polyvinyl chloride (PVC) type plastics. The key process parameters were investigated in this paper included temperatures, residence time, pressure, type of catalysts.

Izvorni jezik
Engleski

Znanstvena područja
Kemijsko inženjerstvo

POVEZANOST RADA