Naslov
Solid recovered fuels in the cement industry – semi-automated sample preparation unit as a means for facilitated practical application

Autori
Aldrian, Alexia ; Šarc, Renato ; Pomberger, Roland ; Lorber, Karl E. ; Sipple, Ernst-Michael

Izvornik
Waste management & research (0734-242X) 34 (2016), 3; 254-264

Vrsta, podvrsta i kategorija rada
Radovi u časopisima, članak, ostalo

Ključne riječi
alternative fuel ; solid recovered fuel (SRF) ; ‘Hotdisc SRF’ ; representative sampling ; sample preparation ; comminution ; quality assurance

Sažetak
One of the challenges for the cement industry is the quality assurance of alternative fuel (e.g. solid recovered fuel, SRF) in co-incineration plants – especially for inhomogeneous alternative fuels with large particle sizes (d95⩾100 mm), which will gain even more importance in the substitution of conventional fuels due to low production costs. Existing standards for sampling and sample preparation do not cover the challenges resulting from these kinds of materials. A possible approach to ensure quality monitoring is shown in the present contribution. For this, a specially manufactured, automated comminution and sample divider device was installed at a cement plant in Rohožnik. In order to prove its practical suitability with methods according to current standards, the sampling and sample preparation process were validated for alternative fuel with a grain size >30 mm (i.e. d95=approximately 100 mm), so-called ‘Hotdisc SRF’. Therefore, series of samples were taken and analysed. A comparison of the analysis results with the yearly average values obtained through a reference investigation route showed good accordance. Further investigations during the validation process also showed that segregation or enrichment of material throughout the comminution plant does not occur. The results also demonstrate that compliance with legal standards regarding the minimum sample amount is not sufficient for inhomogeneous and coarse particle size alternative fuels. Instead, higher sample amounts after the first particle size reduction step are strongly recommended in order to gain a representative laboratory sample.

Izvorni jezik
Engleski

Znanstvena područja
Interdisciplinarne tehničke znanosti

POVEZANOST RADA