Naslov
A comparison of the tolerance analysis methods in the open-loop assembly

Autori
Kosec, Petar ; Škec, Stanko ; Miler, Daniel

Izvornik
Advances in production engineering & management (1854-6250) 15 (2020), 1; 44-56

Vrsta, podvrsta i kategorija rada
Radovi u časopisima, članak, znanstveni

Ključne riječi
Assembly ; Open-loop assembly ; Tolerance analysis ; Computer aided tolerancing ; Tolerance chart analysis ; Unified Jacobian-torsor model ; Monte Carlo method ; Vector-loop analysis

Sažetak
Dimensional and geometric tolerances affect both the cost and the functionality of a given product. Finding the acceptable trade-off between the two is among the common engineering tasks. Thus, many tolerance analysis methods are developed to help engineers and assist in the decision-making process. In this article, the authors have assessed four tolerance analysis methods by applying them to the open- loop assembly. The results obtained by the tolerance chart (worst-case) method, Monte- Carlo simulation, vector-loop analysis, and the Unified Jacobian-torsor model were analysed and compared. Additionally, the overview and application guidelines are included for each of the methods, aiming to help both researchers and practitioners. The results have confirmed that there are significant variations in the outputs across the observed methods, implying the need for informed method selection.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA