Pregled bibliografske jedinice broj: 1050668
Partial Rub Detection Based on Instantaneous Angular Speed Measurement and Variational Mode Decomposition
Partial Rub Detection Based on Instantaneous Angular Speed Measurement and Variational Mode Decomposition // Journal of Vibration Engineering & Technologies, 8 (2020), 2; 351-364 doi:10.1007/s42417-019-00177-2 (međunarodna recenzija, članak, znanstveni)
CROSBI ID: 1050668 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Partial Rub Detection Based on Instantaneous
Angular Speed Measurement and Variational Mode
Decomposition
Autori
Braut, Sanjin ; Žigulić, Roberto ; Skoblar, Ante ; Štimac Rončević, Goranka
Izvornik
Journal of Vibration Engineering & Technologies (2321-3558) 8
(2020), 2;
351-364
Vrsta, podvrsta i kategorija rada
Radovi u časopisima, članak, znanstveni
Ključne riječi
Partial rub, Fault detection, Instantaneous angular speed measurement, Variational mode decomposition (VMD)
Sažetak
Purpose During their lifetime, rotating machines experience various problems. Among others, rotor–stator rubbing is one of the most common problems encountered. Therefore, this paper proposes a two-step procedure for rotor– stator partial rub detection. Methods The first step applies the instantaneous angular speed (IAS) measurement. In this paper, the IAS signal is measured at low to moderate sampling rates as an analog signal from the zebra tape encoder. The correction of encoder segment non- uniformity is also briefly presented in the paper. As a means of coping with the nonlinear signal of the partial rub, the variational mode decomposition (VMD) is proposed in the paper, as the second step of the detection procedure. The VMD is a relatively new method with promising results for machinery fault detection. Results The partial rub detection tool was tested on the laboratory test rig under three different rotor operating conditions ; firstly, for constant rotor speed without rubbing, secondly for rotor running at near critical constant speed with light rotor– stator rubbing, and finally under the condition which describes capabilities of the proposed rubbing detection procedure during variable rotor speed operation. The measurements were taken with an optical phase sensor pointed at the zebra tape encoder. The results are presented in the shape of rotor orbits, IAS signals, FFT spectra of IAS signals and VMD spectrograms of IAS signals. Conclusions It can be concluded that VMD spectrogram of IAS signal yields a clear detection criterion for light partial rotor– stator rubbing by the presence of 1/2×, 3/2× and 5/2× fractional harmonics. Depending on the analyzed conditions of partial rubbing, at least one of the mentioned fractional harmonics should appear.
Izvorni jezik
Engleski
Znanstvena područja
Strojarstvo, Temeljne tehničke znanosti
POVEZANOST RADA
Projekti:
uniri-tehnic-18-225
Ustanove:
Tehnički fakultet, Rijeka
Profili:
Roberto Žigulić
(autor)
Sanjin Braut
(autor)
Goranka Štimac Rončević
(autor)
Ante Skoblar
(autor)
Citiraj ovu publikaciju:
Časopis indeksira:
- Web of Science Core Collection (WoSCC)
- Science Citation Index Expanded (SCI-EXP)
- SCI-EXP, SSCI i/ili A&HCI
- Scopus