Naslov
Reliable experimental data as a key factor for design of mechanical structures

Autori
Brnić, Josip ; Kršćanski, Sanjin ; Brčić, Marino ; Geng, Lin ; Niu, Jitai ; Ding, Biao

Izvornik
Structural Engineering and Mechanics, An International Journal (1225-4568) 72 (2019), 2; 245-256

Vrsta, podvrsta i kategorija rada
Radovi u časopisima, članak, znanstveni

Ključne riječi
Steel 18CrNi8 ; mechanical properties ; creep behavior and creep modeling ; fatigue and fatigue limit

Sažetak
The experimentally determined mechanical behavior of the material under the prescribed service conditions is the basis of advanced engineering optimum design. To allow experimental data on the behavior of the material considered, uniaxial stress tests were made. The aforementioned tests have enabled the determination of mechanical properties of material at different temperatures, then, the material\'s resistance to creep at various temperatures and stress levels, and finally, insight into the uniaxial high cyclic fatigue of the material under different applied stresses for prescribed stress ratio. Based on fatigue tests, using modified staircase method, fatigue limit was determined. All these data contributes the reliability of the use of material in mechanical structures. Data representing mechanical properties are shown in the form of engineering stress-strain diagrams ; creep behavior is displayed in the form of creep curves while fatigue of the material is presented in the form of S-N (maximum applied stress versus number of the cycles to failure) curve. Material under consideration was 18CrNi8 (1.5920) steel. Ultimate tensile strength and yield strength at room temperature and at temperature of 600 degree celcius: [sigma m, 20/600=(613/156)MPa ; sigma0.2, 20/600= (458/141)MPa], as well as endurance (fatigue) limit at room temperature and stress ratio of R=-1: (sigmaf, 20, R=−1 = 285.1MPa).

Izvorni jezik
Engleski

Znanstvena područja
Brodogradnja, Strojarstvo, Temeljne tehničke znanosti

POVEZANOST RADA