Naslov
Determination of plasticity of steel N-80 by torsion test and its important for practice

Autori
Mamuzić, Ilija ; Balenović, M. ; Golja, Marijan

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
Zbornik radova sa 4. Međunarodnog simpozija o plastičnosti i otporu deformacije / Blečić, Svetozar ; Mišković, Nada - Podgorica : Nikšić : Metalurški fakultet Titograd, Željezara “Boris Kidrić“ Nikšić, Kombinat aluminija Titograd, 1984, 115-128

Skup
4. međunarodni simpozij o plastičnosti i otporu deformacije

Mjesto i datum
Herceg Novi, Jugoslavija, 26.06.1984. - 28.06.1984

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
steel N-80 ; seamles tubes ; plasticity ; torsion test ; metallorgraphic analysis

Sažetak
By testing plasticity of the steel N-80 ( Č.8380), which is used for the production of special seamless tubes, on torsion plastometr TC-01 ADAMEL LHOMBARGI high plasticity was found in the temperature range 900-1200°C. Two melts with maximum and minimun carbon content were tested and it was found out that plasticity increases with the production level, the lowest is on cast block, and the highest is on tube blank with the production level 1, 5. At the same time these results were compared with the plasticity test results of the third melt N-80, which had been rejected during the production of seamless tubes. Far lower plasticity was established ( the number of twists to failure on the plastometer nL was 4-5 times smaller that with the two previou melta ). The cause of low plasticity was established by detailed metallographic analysis.

Izvorni jezik
Engleski

Znanstvena područja
Metalurgija

POVEZANOST RADA