Pregled bibliografske jedinice broj: 997896
Properties of High Strength Low Alloy Steel after Welding
Properties of High Strength Low Alloy Steel after Welding // Contemporary materials 2018 / Kuzmanović, Rajko ; Mirjanić, Dragoljub (ur.).
Banja Luka: ANURS Banja Luka, 2019. str. 55-63 (poster, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)
CROSBI ID: 997896 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Properties of High Strength Low Alloy Steel after Welding
Autori
Kosec, Gorazd ; Gojić, Mirko ; Kožuh, Stjepan ; Kosec, Borut ; Ivanić, Ivana
Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni
Izvornik
Contemporary materials 2018
/ Kuzmanović, Rajko ; Mirjanić, Dragoljub - Banja Luka : ANURS Banja Luka, 2019, 55-63
Skup
Contemporary Materials
Mjesto i datum
Banja Luka, Bosna i Hercegovina, 02.09.2018. - 03.09.2018
Vrsta sudjelovanja
Poster
Vrsta recenzije
Međunarodna recenzija
Ključne riječi
High Strength Low Alloy Steel, welding, microstructure
Sažetak
Niomol 490 K steel belongs to the group of High Strength Low Alloy Steel (HSLA). The aim of this study was to determine the transition temperature of the Charpy impact toughness of welded Niomol 490 K steel. The samples for testing of the Charpy impact toughness were heat treated in order to obtain different microstructures. Metallographic samples were prepared according to the classical procedure. For microstructure analysis an optical microscope and scanning electron microscope were used. Heating that appears at the deposition of the next welding layer was simulated by short heating into the two-phase region (austenite and ferrite). It is found that impact toughness is highly dependent on steels microstructure. The transition temperature of the Niomol 490 K steel in the initial state was about -67 ° C. After water quenching from 920 °C, the Charpy impact toughness of the upper level was reduced to about a half of the value than that of the steel in the initial state. After reheating to 750 °C, the toughness was reduced by approximately half of the value that in water quenched sample. The fracture surface in the region of a completely ductile fracture shows the areas of shear decohesion. The transition from the brittle to the ductile fracture shows that the crack propagation path expands with the plane slip to the first tiny dimples.
Izvorni jezik
Engleski
Znanstvena područja
Metalurgija
POVEZANOST RADA
Projekti:
GOJIC-CRO-SLO 2018/2019 - Analiza prijelomnih površina mikrolegiranih čelika (Gojić, Mirko, MZO ) ( CroRIS)
Ustanove:
Metalurški fakultet, Sisak