Naslov
New insights into rotation welding of beech

Autori
Župčić, Ivica ; Bogner, Andrija ; Grbac, Ivica ; Lozančić, Ivan

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
Wood is good - transfer of knowledge in practice as away out of the crisis / Radovan Despot - Zagreb : University of Zagreb, Faculty of forestry ; Innovawood, 2010, 147-152

ISBN
978-953-292-018-5

Skup
Wood is good - transfer of knowledge in practice as away out of the crisis

Mjesto i datum
Zagreb, Hrvatska, 15.10.2010

Vrsta sudjelovanja
Poster

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
rotation welding; role of fits (tightness); strength of welded joint; beech

Sažetak
Wood welding enables joining of wood elements without the use of adhesives or any other bonding agents, by using heat that appears on contact surfaces due to friction. Melting of the surface layers of wood in contact occurs during the welding process, thus creating a melt, which, after turning solid, becomes a strong joint which is as firm as a glued joint. Important factors in dowel welding process, aside from the size of the clearance, are wood moisture, duration of welding, wood type, impact of welding depth, rotation frequency and some less important factors. This paper describes the previous insights into wood welding, and own results of research conducted at the Faculty of Forestry of the University in Zagreb. Impact of the fit size (tightness) on the strength of a dowel that was rotationally welded perpendicular to the direction of wood fibres was investigated. The research has shown that the rotationally welded dowel achieved the greatest strength when tightness was 2 to 2.5 mm. If tightness is above or less than the mentioned, the embedded force or strength of the joint is reduced.

Izvorni jezik
Engleski

Znanstvena područja
Drvna tehnologija

POVEZANOST RADA