Pretražite po imenu i prezimenu autora, mentora, urednika, prevoditelja

Napredna pretraga

Pregled bibliografske jedinice broj: 394586

Kinetic and structural factors in graft polymerization of styrene on polyolefins


Ranogajec, Franjo
Kinetic and structural factors in graft polymerization of styrene on polyolefins // Polimeri : Časopis za plastiku i gumu, 29 (2008), 4; 217-227 (podatak o recenziji nije dostupan, autorski pregled, znanstveni)


CROSBI ID: 394586 Za ispravke kontaktirajte CROSBI podršku putem web obrasca

Naslov
Kinetic and structural factors in graft polymerization of styrene on polyolefins

Autori
Ranogajec, Franjo

Izvornik
Polimeri : Časopis za plastiku i gumu (0351-1871) 29 (2008), 4; 217-227

Vrsta, podvrsta i kategorija rada
Radovi u časopisima, autorski pregled, znanstveni

Ključne riječi
graft polymerization ; polyolefins ; styrene ; grafting methods ; kinetic factors ; structural factors ; specimen density and thickness ; solvent effect ; crosslinking effect ; gel effect

Sažetak
Radiation grafting of monomers on polymers is radical polymerization which usually takes place in viscous medium and quite often in a micro-heterogeneous semicrystalline matrix. The role of kinetic and structural factors in the graft polymerization was investigated. Grafting of styrene on polyethylene and polypropylene was initiated by radiation methods (direct irradiation of polymer and monomer, preirradiation of polymer in vacuum, preirradiation of polymer in air) and by chemical initiators (azoisobutyronitrile and benzoil peroxide). The effect of temperature, dose rate, polymer density and specimen thickness, addition of methanol to monomer and pre-crosslinking of polymer on the grafting was investigated. It was shown that a steady-state assumption, which is conventional in homopolymerization, can be applied for radiation grafting initiated by direct irradiation of styrene and polyethylene or polypropylene. Swelling measurements have shown that monomer supply in polymer is higher than monomer consumption and the diffusion is not rate-determine step. The rate of grafting was constant and at the dose rates lower than 102 Gy/h the square root dependence of grafting rate on dose rate was valid as classical equation for homopolymerization request. The independence of the grafting rate on the dose rate above 102 Gy/h was due to participation of primary radicals in the termination reaction. The grafting rate and yield increased with the increase of the polymer density (0.92-0.96 g/cm3) and the film and foil thickness (0.05-1 mm) due to the increased viscosity of the reaction medium and consequently decreased rate of termination but lower yield of grafting and very slow reaction was observed for very rigid high density thick foils, especially at lower temperature. The effect of structural factors and crosslinking on grafting reaction is discussed.

Izvorni jezik
Engleski

Znanstvena područja
Kemija



POVEZANOST RADA


Projekti:
098-0982904-2955 - Odnosi struktura-svojstvo modificiranih polimernih materijala (Pucić, Irina, MZOS ) ( CroRIS)

Ustanove:
Institut "Ruđer Bošković", Zagreb

Profili:

Avatar Url Franjo Ranogajec (autor)

Poveznice na cjeloviti tekst rada:

Hrčak

Citiraj ovu publikaciju:

Ranogajec, Franjo
Kinetic and structural factors in graft polymerization of styrene on polyolefins // Polimeri : Časopis za plastiku i gumu, 29 (2008), 4; 217-227 (podatak o recenziji nije dostupan, autorski pregled, znanstveni)
Ranogajec, F. (2008) Kinetic and structural factors in graft polymerization of styrene on polyolefins. Polimeri : Časopis za plastiku i gumu, 29 (4), 217-227.
@article{article, author = {Ranogajec, Franjo}, year = {2008}, pages = {217-227}, keywords = {graft polymerization, polyolefins, styrene, grafting methods, kinetic factors, structural factors, specimen density and thickness, solvent effect, crosslinking effect, gel effect}, journal = {Polimeri : \v{C}asopis za plastiku i gumu}, volume = {29}, number = {4}, issn = {0351-1871}, title = {Kinetic and structural factors in graft polymerization of styrene on polyolefins}, keyword = {graft polymerization, polyolefins, styrene, grafting methods, kinetic factors, structural factors, specimen density and thickness, solvent effect, crosslinking effect, gel effect} }
@article{article, author = {Ranogajec, Franjo}, year = {2008}, pages = {217-227}, keywords = {graft polymerization, polyolefins, styrene, grafting methods, kinetic factors, structural factors, specimen density and thickness, solvent effect, crosslinking effect, gel effect}, journal = {Polimeri : \v{C}asopis za plastiku i gumu}, volume = {29}, number = {4}, issn = {0351-1871}, title = {Kinetic and structural factors in graft polymerization of styrene on polyolefins}, keyword = {graft polymerization, polyolefins, styrene, grafting methods, kinetic factors, structural factors, specimen density and thickness, solvent effect, crosslinking effect, gel effect} }

Časopis indeksira:


  • Scopus


Uključenost u ostale bibliografske baze podataka::


  • CAB Abstracts
  • CA Search (Chemical Abstracts)
  • Chemical Engineering and Biotechnology Abstracts
  • World Surface Coatings Abstracts
  • World Textiles
  • Chemical Safety New Base
  • DIALOG Sourceone (SM) Eng.
  • El Compendex Plus: Maro Polymer Notes
  • Mechanical Engineering Abstracts
  • Pascal
  • RAPRA Rubber & Plastics
  • Referativny Zhurnal
  • SCOPUS
  • Textile Technology Digest
  • World Translations Index.





Contrast
Increase Font
Decrease Font
Dyslexic Font