Naslov
Gear Tooth-Root Stress of Single Pair Contact

Autori
Marunić, Gordana

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
MicroCAD 2004 International Scientific Conference / Gyla, Patko - Miskolc : Innovation and Technology Transfer Centre, University of Miskolc, 2004, 59-64

Skup
MicroCAD 2004 International Scientific Conference

Mjesto i datum
Miskolc, Mađarska, 18.03.2004. - 19.03.2004

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
Spur Gear; Root Stress; Single Contact

Sažetak
Based upon the developed complex pinion-wheel 3D FEM numerical model, the tooth-root stress was determined of spur gear for the meshing phase. The obtained results pointed to maximum stress magnitude reached for the single pair tooth contact, and these fillet stresses have been analysed in this paper, related to the gear geometrical parameters taken into account. The tooth root stress was determined for the gear, which can be considered as narrow and wider faced one. As the fillet stress behaviour is strongly influenced by the rim thickness, there have been considered solid and thin-rimmed gear. These parameters, the tooth facewidth and the rim thickness, have been followed for the gears of different geometry determined by fewer and larger number of teeth. Equivalent von Mises stress was determined along with maximum tangential stress component on tensile side of the loaded tooth root, and the comparison with nominal bending stress according to the ISO calculation procedure was accomplished.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA