Naslov
Measuring setdown output parameter of cross-wire welded mesh with reconfigurable measuring system

Autori
Vlatković, Maja ; Čabrijan, Ivana ; Pavletić, Duško ; Doboviček, Sandro

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), stručni

Izvornik
"Mechanical Technologies and Structural Materials 2022" / Jozić, Sonja ; Lela, Branimir ; Gjeldum, Nikola - Split : Hrvatsko društvo za zaštitu materijala (HDZaMa), 2022, 169-174

Skup
11th International Conference Mechanical Technologies and Structural Materials (MTSM 2022)

Mjesto i datum
Split, Hrvatska, 22.09.2022. - 23.09.2022

Vrsta sudjelovanja
Poster

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
Setdown ; Cross-wire welding ; Wire mesh ; Reconfigurable measuring system ; Machine vision ; Quality control

Sažetak
This paper describes setdown output parameter dimension measuring procedure for the wire mesh obtained by the cross-wire welding process. The measurement is performed by non-contact reconfigurable measurement system enhanced with a machine vision. Advantage of this kind of a system are found in a fact that, apart from the necessary dimensions, also images of the welds are obtained, saved and used for further analysis of the parameters influence on the final weld appearance. The analysis of the measuring system is shown in the paper in order to confirm that the measuring system is acceptable, also the measurement results are compared with ones obtained by conventional method. Analysis of the measurement system also shows that the change of measuring operator has no influence on the obtained measurements. Measurements of the setdown dimensions are shown in the results section of the paper and it was determined that some measurements exceed the control limits.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA