Pregled bibliografske jedinice broj: 1178312
Aging-dependent changes in mechanical properties of the new generation of bulk-fill composites
Aging-dependent changes in mechanical properties of the new generation of bulk-fill composites // Materials, 15 (2022), 3; 902, 16 doi:10.3390/ma15030902 (međunarodna recenzija, članak, znanstveni)
CROSBI ID: 1178312 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Aging-dependent changes in mechanical properties of the new generation of bulk-fill composites
Autori
Marović, Danijela ; Par, Matej ; Macan, Matea ; Klarić, Nikolina ; Plazonić, Iva ; Tarle, Zrinka
Izvornik
Materials (1996-1944) 15
(2022), 3;
902, 16
Vrsta, podvrsta i kategorija rada
Radovi u časopisima, članak, znanstveni
Ključne riječi
aging ; bulk-fill ; composite ; ethanol ; Weibull analysis ; flexural strength ; flexural modulus ; water sorption ; solubility ; degree of conversion
Sažetak
This study evaluated the behavior of a new generation of bulk-fill resin composites after prolonged exposure to an aqueous environment and accelerated aging in ethanol. Six bulk-fill materials were tested (Tetric PowerFill, Filtek One Bulk Fill Restorative, Tetric EvoCeram Bulk Fill, Fill-Up!, Tetric PowerFlow, SDR Plus Bulk Fill Flowable) and compared to two conventional reference materials (Tetric EvoCeram and Tetric EvoFlow). Flexural strength, modulus, and Weibull parameters were examined at three time points: 1 day, 30 days, and 30 days followed by ethanol immersion. Degree of conversion after 30 days, water sorption, and solubility up to 90 days were also investigated. Filtek One Bulk Fill had the highest flexural strength and modulus among the tested materials, followed by Tetric PowerFill and SDR plus. Flexural strength and modulus of high- viscosity bulk-fill materials showed higher stability after accelerated aging in ethanol compared to their low-viscosity counterparts and reference materials. After 30 days, the degree of conversion was above 80% for all tested materials. Dual-cure material Fill-Up! was the best-cured material. The water sorption was highest for Fill- Up!, Filtek One Bulk Fill Restorative, and Tetric EvoFlow, while solubility was highest for Tetric EvoCeram. After aging in water and ethanol, new generation high-viscosity bulk-fill materials showed better mechanical properties than low- viscosity bulk-fill and conventional composites under extended light curing conditions.
Izvorni jezik
Engleski
Znanstvena područja
Dentalna medicina
POVEZANOST RADA
Projekti:
HRZZ-IP-2019-04-6183 - Biomimetički inteligentni kompozitni sustavi (BIOMICS) (Tarle, Zrinka, HRZZ - 2019-04) ( CroRIS)
Ustanove:
Stomatološki fakultet, Zagreb
Citiraj ovu publikaciju:
Časopis indeksira:
- Current Contents Connect (CCC)
- Web of Science Core Collection (WoSCC)
- Science Citation Index Expanded (SCI-EXP)
- SCI-EXP, SSCI i/ili A&HCI
- Scopus