Pregled bibliografske jedinice broj: 1145453
Experimental Data Contributing to the Elusive Surface Charge of Inert Materials in Contact with Aqueous Media
Experimental Data Contributing to the Elusive Surface Charge of Inert Materials in Contact with Aqueous Media // Colloids and interfaces, 5 (2021), 1; 6, 19 doi:10.3390/colloids5010006 (međunarodna recenzija, članak, znanstveni)
CROSBI ID: 1145453 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Experimental Data Contributing to the Elusive
Surface Charge of Inert Materials in Contact with
Aqueous Media
Autori
Barišić, Antun ; Lützenkirchen, Johannes ; Bebić, Nikol ; Li, Qinzhi ; Hanna, Khalil ; Shchukarev, Andrey ; Begović, Tajana
Izvornik
Colloids and interfaces (2504-5377) 5
(2021), 1;
6, 19
Vrsta, podvrsta i kategorija rada
Radovi u časopisima, članak, znanstveni
Ključne riječi
surface charge ; zeta-potential ; PTFE ; graphite ; graphene
Sažetak
We studied the charging of inert surfaces (polytetrafluoroethylene, i.e., PTFE ; graphite ; graphene ; and hydrophobic silica) using classical colloid chemistry approaches. Potentiometric titrations showed that these surfaces acquired less charge from proton-related reactions than oxide minerals. The data from batch-type titrations for PTFE powder did not show an effect of ionic strength, which was also in contrast with results for classical colloids. In agreement with classical colloids, the electrokinetic results for inert surfaces showed the typical salt level dependence. In some cases, the point of zero net proton charge as determined from mass and tentatively from acid–base titration differed from isoelectric points, which has also been previously observed, for example by Chibowski and co-workers for ice electrolyte interfaces. Finally, we found no evidence for surface contaminations of our PTFE particles before and after immersion in aqueous solutions. Only in the presence of NaCl-containing solutions did cryo-XPS detect oxygen from water. We believe that our low isoelectric points for PTFE were not due to impurities. Moreover, the measured buffering at pH 3 could not be explained by sub-micromolar concentrations of contaminants. The most comprehensive explanation for the various sets of data is that hydroxide ion accumulation occurred at the interfaces between inert surfaces and aqueous solutions.
Izvorni jezik
Engleski
Znanstvena područja
Kemija
POVEZANOST RADA
Projekti:
HRZZ-IP-2014-09-6972 - Električno nabijanje međupovršina na granici čvrsta faza/vodena otopina elektrolita (SAQUINT) (Preočanin, Tajana, HRZZ - 2014-09) ( CroRIS)
Ustanove:
Prirodoslovno-matematički fakultet, Zagreb
Citiraj ovu publikaciju:
Časopis indeksira:
- Web of Science Core Collection (WoSCC)
- Emerging Sources Citation Index (ESCI)
- Scopus