Pregled bibliografske jedinice broj: 1103004
Comparison of design methods for openings in cylindrical shells under internal pressure reinforced by flush (set-on) nozzles
Comparison of design methods for openings in cylindrical shells under internal pressure reinforced by flush (set-on) nozzles // PROCEEDINGS 15th International Research/Expert Conference ”Trends in the Development of Machinery and Associated Technology” / Dr. Sabahudin Ekinović, Dr. Joan Vivancos Calvet, Dr. Emin Tacer (ur.).
Zenica: University of Zenica, Faculty of Mechanical Engineering, 2011. str. 1001-1004 (predavanje, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)
CROSBI ID: 1103004 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Comparison of design methods for openings in
cylindrical shells under internal pressure
reinforced by flush (set-on) nozzles
Autori
Kacmarcik, Josip ; Vukojevic, Nedeljko
Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni
Izvornik
PROCEEDINGS 15th International Research/Expert Conference ”Trends in the Development of Machinery and Associated Technology”
/ Dr. Sabahudin Ekinović, Dr. Joan Vivancos Calvet, Dr. Emin Tacer - Zenica : University of Zenica, Faculty of Mechanical Engineering, 2011, 1001-1004
Skup
15th International Research/Expert Conference ”Trends in the Development of Machinery and Associated Technology”
Mjesto i datum
Prag, Češka Republika, 12.09.2011. - 18.09.2011
Vrsta sudjelovanja
Predavanje
Vrsta recenzije
Međunarodna recenzija
Ključne riječi
flush nozzle, set-on nozzle, cylindrical pressure vessel
Sažetak
In this paper a comprehensive comparison of three design methods for openings in cylindrical shells under internal pressure (pressure vessels) reinforced by flush (set-on) nozzles has been carried out. The design methods are used in EN 13445-3: Unfired pressure vessels-Part 3: Design, ASME pressure vessel code and PD 5500: Specification for unfired fusion welded pressure vessels. The calculation procedures used in the three methods are significantly different, so the comparison has been based on the maximum permissible design pressures for 45 specific geometries calculated using the three methods.
Izvorni jezik
Engleski
Znanstvena područja
Strojarstvo
