Pregled bibliografske jedinice broj: 1077468
Strength Calculation and Optimization of Boat Crane
Strength Calculation and Optimization of Boat Crane // Lecture Notes in Networks and Systems / Mitrović, N. ; Mladenović, G. ; Mitrović, A. (ur.).
Zlatibor: Springer, 2020. str. 35-52 doi:10.1007/978-3-030-58362-0_3
CROSBI ID: 1077468 Za ispravke kontaktirajte CROSBI podršku putem web obrasca
Naslov
Strength Calculation and Optimization of Boat
Crane
Autori
Morosavljević, Janko ; Kozak, Dražan ; Monkova, Katarina ; Damjanović, Darko
Vrsta, podvrsta i kategorija rada
Poglavlja u knjigama, znanstveni
Knjiga
Lecture Notes in Networks and Systems
Urednik/ci
Mitrović, N. ; Mladenović, G. ; Mitrović, A.
Izdavač
Springer
Grad
Zlatibor
Godina
2020
Raspon stranica
35-52
ISBN
978-3-030-58361-3
ISSN
2367-3370
Ključne riječi
Strength ; Optimization ; Boat crane
Sažetak
By inspecting the existing constructional designs of boat cranes and the requirements which need to be fulfilled, the new constructional design of the boat crane is made. After determining the critical position of the crane in the form of a load, calculation of the inside diameters of cylinders is made and optimized depending on the maximum axial force. Numeric calculation of the stresses and total deformations in software ANSYS Workbench has proved that the design of crane has met all the requirements imposed on the strength. After designing the boat crane and preforming the strength calculations, it is necessary to analyze the motion of the designed crane construction. Boat crane is designed with hydraulic cylinders and rotation around the shaft using a hydraulic motor. Therefore, it is necessary to create a scheme of a hydraulic system of the crane. During the designing and strength analysis, no material exploitation was taken into account and reinforcements were added only to reduce the equivalent stresses and the maximum total deformation of the crane. Due to the possible oversizing of the reinforcements, the optimization was performed by the response surface optimization method. Optimization was performed to minimize the mass and it has been found that the construction was oversized and the mass was reduced by almost 14 kg.
Izvorni jezik
Engleski
Znanstvena područja
Strojarstvo
Napomena
This proceedings book is a collection of high-
quality peer-reviewed research papers presented
at the International Conference of Experimental
and Numerical Investigations and New
Technologies (CNNTech2020) held at Zlatibor,
Serbia, from 29th June to 2nd July 2020.
POVEZANOST RADA
Projekti:
MZOS-152-1201910-1909 - Analiza i procjena loma konstrukcija iz anizotropnih materijala (Kozak, Dražan, MZOS ) ( CroRIS)
Ustanove:
Strojarski fakultet, Slavonski Brod
