Modelling and simulation of deformation of cutting tool during cutting (CROSBI ID 672745)
Prilog sa skupa u zborniku | ostalo | međunarodna recenzija
Podaci o odgovornosti
Mikulić, Ivan ; Stoić, Katarina ; Stoić, Marija ; Stoić, Antun
engleski
Modelling and simulation of deformation of cutting tool during cutting
This work simulates the stress and deformation of the tool holder for turning and determines the elastic deformation value of the tip of the cutting insert. Cross-section of tool holder was 32x25 mm and holder with cutting insert were modeled in SolidWorks. The ANSYS structural analysis software was used to simulate the load using the finite element method. Two size elements of the network are selected. One network has elements with size of 5 mm, and the other is a mesh with size of 1 mm. The simulation was carried out for five different values of force acting on the model. Each of these 5 values of forces was carried out through simulation on the above-mentioned two different finite element network arrangement
FEM, cutting tool, deformation, optimisation
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
Podaci o prilogu
134-139.
2018.
objavljeno
Podaci o matičnoj publikaciji
Proceedings of TEAM 2018 9th international Scientific and expert conference
Lalić, Bojan
Novi Sad: Faculty of technical sciences Novi Sad
978-86-6022-098-3
Podaci o skupu
9th International Scientific and Expert Conference (TEAM 2018)
predavanje
10.10.2018-12.10.2018
Novi Sad, Srbija