Nalazite se na CroRIS probnoj okolini. Ovdje evidentirani podaci neće biti pohranjeni u Informacijskom sustavu znanosti RH. Ako je ovo greška, CroRIS produkcijskoj okolini moguće je pristupi putem poveznice www.croris.hr
izvor podataka: crosbi

Wear of induction cladded coating in the abrasive mass at various speeds and impact angles (CROSBI ID 260242)

Prilog u časopisu | izvorni znanstveni rad | međunarodna recenzija

Heffer, Goran ; Samardžić, Ivan ; Schauperl, Zdravko ; Vidaković, Ivan Wear of induction cladded coating in the abrasive mass at various speeds and impact angles // Tehnički vjesnik : znanstveno-stručni časopis tehničkih fakulteta Sveučilišta u Osijeku, 25 (2018), 6; 1776-1782. doi: doi.org/10.17559/TV-20180706121545

Podaci o odgovornosti

Heffer, Goran ; Samardžić, Ivan ; Schauperl, Zdravko ; Vidaković, Ivan

engleski

Wear of induction cladded coating in the abrasive mass at various speeds and impact angles

The wear of induction cladded coating during motion was investigated through the abrasive mass at a speed of 1.0 to 3.0 m/s and the impact angle of abrasive particles with a worn surface of 0° to 90°. Cladding was performed by using Ni-Cr-Si-B-Fe flame spraying powder. Experimental research was carried out by using the Response Surface Method (RSM) and Central Composite Design (CCD). Analysis of variance proved that both motion speed and impact angle had significant impact on the wear of coating, both individually and interactively. Motion speed had the greatest influence, and the interaction of speed and angle had the least influence. The wear rate increased along with the motion speed increase, and the influence of the impact angle depends on the wear speed. At a speed of 1 m/s, the wear increases along with the increase of angle from 0° to 45° and then continues to decrease up to the angle of 90°. At a speed of 2 m/s, the wear increases along with the angle increase from 0° to 30° and then continues to decrease up to the angle of 90°. At a speed of 3 m/s, the wear increases along with the angle increase from 0° to 20° and then decreases as the angle increases up to 90°. Based on the statistical data processing, this research developed the mathematical model of wear in the form of quadratic polynomial that describes the influences of input variables in individual and interactive form.

abrasive mass ; flame spraying powder ; impact angle ; induction cladded coating ; motion speed ; wear rate

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

Podaci o izdanju

25 (6)

2018.

1776-1782

objavljeno

1330-3651

1848-6339

doi.org/10.17559/TV-20180706121545

Trošak objave rada u otvorenom pristupu

Povezanost rada

Strojarstvo

Poveznice
Indeksiranost