Napredna pretraga

Pregled bibliografske jedinice broj: 89963

Abrasion Resistance Improvement of Vertical Turbine Pump Parts


Šimunović, Katica; Ivušić, Vinko; Grilec, Krešimir
Abrasion Resistance Improvement of Vertical Turbine Pump Parts // Proceedings of the 3rd Aimeta International Tribology Conference : AITC 2002
Salerno: Italian Association for Theoretical and Applied Mechanics, 2002. (predavanje, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)


Naslov
Abrasion Resistance Improvement of Vertical Turbine Pump Parts

Autori
Šimunović, Katica ; Ivušić, Vinko ; Grilec, Krešimir

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
Proceedings of the 3rd Aimeta International Tribology Conference : AITC 2002 / - Salerno : Italian Association for Theoretical and Applied Mechanics, 2002

Skup
Aimeta International Tribology Conference (3 ; 2002)

Mjesto i datum
Vietri sul Mare, Salerno, Italija, 18-20.09.2002.

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
Abrasion; vertical turbine pump; shaft sleeve; thermal spraying; NiCr and NiCrWC coating

Sažetak
Abrasion wear of shaft sleeves on vertical turbine pump resulted in considerable losses, so some tribological activities were applied to reduce them. These tribological activities which are therefore proposed to reduce wear are: application of thermal spray coatings directly to the shaft journals, by which the use of shaft sleeves might be avoided and direct and indirect costs caused by these parts getting worn out, reduced. Efficiency of the proposed tribological wear reduction activities has been confirmed by laboratory test method for measuring abrasion wear using "dry sand/rubber wheel" apparatus (ASTM G65-94 standard). Specimens with NiCr and NiCrWC coatings proved better abrasion resistance than specimens of shaft sleeve material (steel X55CrMo14, hardened and tempered, hardness 50 HRC). Comparing abrasion resistance of the coatings, it was evident that the NiCr and NiCrWC coatings had approximately the same loss of mass after 100 revolutions of wheel. However, after 2000 revolutions of wheel, NiCr coatings showed significantly lower resistance than NiCrWC coatings. Higher abrasion resistance of NiCrWC coating after a longer period of wear was the result of high hardness tungsten carbide presence in the matrix. According to the results of testing, the best effects (better abrasion resistance) would therefore be achieved by the application of NiCrWC coating to the shaft journals.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo



POVEZANOST RADA


Projekt / tema
0120027
0152014

Ustanove
Fakultet strojarstva i brodogradnje, Zagreb,
Strojarski fakultet, Slavonski Brod