Napredna pretraga

Pregled bibliografske jedinice broj: 881510

Influence of kinematic factors of friction stir welding on the characteristics of welded joints of forged plates made of EN AW 7049 A aluminium alloy


Perović, Milenko; Baloš, Sebastian; Kozak, Dražan; Bajić, Darko; Vuherer, Tomaž
Influence of kinematic factors of friction stir welding on the characteristics of welded joints of forged plates made of EN AW 7049 A aluminium alloy // Tehnički vjesnik : znanstveno-stručni časopis tehničkih fakulteta Sveučilišta u Osijeku, 24 (2017), 3; 723-728 doi:10.17559/TV-20160417122830 (međunarodna recenzija, članak, znanstveni)


Naslov
Influence of kinematic factors of friction stir welding on the characteristics of welded joints of forged plates made of EN AW 7049 A aluminium alloy

Autori
Perović, Milenko ; Baloš, Sebastian ; Kozak, Dražan ; Bajić, Darko ; Vuherer, Tomaž

Izvornik
Tehnički vjesnik : znanstveno-stručni časopis tehničkih fakulteta Sveučilišta u Osijeku (1330-3651) 24 (2017), 3; 723-728

Vrsta, podvrsta i kategorija rada
Radovi u časopisima, članak, znanstveni

Ključne riječi
Dynamic recrystallization ; friction stir welding ; impact strength ; micro hardness distribution

Sažetak
In this paper, the influence of rotation speed and welding speed on the impact strength, microstructure and cross section micro hardness of FSW welded joints of Al-Zn-Mg-Cu high strength aluminium alloy is studied. Rotation speed was varied from 750 min−1 to 850 min−1 and welding speed from 60 mm/min to 80 mm/min. It was found that the energy of crack propagation is up to three times higher than the energy of crack initiation. This ratio was found by testing the Charpy notched specimens taken from left and right from the weld centre, 4 mm from the notch in a direction opposite to a direction of welding. Micro hardness distribution in the nugget does not show large dissipation of value regardless if the measuring point is in the upper or lower section of the nugget. Weld microstructure characteristics and zones are clearly defined at the basis of grain size and material flow.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo



POVEZANOST RADA


Projekt / tema
152-1201910-1909 - Analiza i procjena loma konstrukcija iz anizotropnih materijala (Dražan Kozak, )

Ustanove
Strojarski fakultet, Slavonski Brod

Autor s matičnim brojem:
Dražan Kozak, (190253)

Časopis indeksira:


  • Web of Science Core Collection (WoSCC)
    • Science Citation Index Expanded (SCI-EXP)
    • SCI-EXP, SSCI i/ili A&HCI
  • Scopus


Uključenost u ostale bibliografske baze podataka:


  • Scopus


Citati