Napredna pretraga

Pregled bibliografske jedinice broj: 881418

Residual stress state in pipe cut ring specimens for fracture toughness testing


Damjanović, Darko; Kozak, Dražan; Marsoner, Stefan; Gubeljak, Nenad
Residual stress state in pipe cut ring specimens for fracture toughness testing // Materialprufung, 59 (2017), 530-535 doi:10.3139/120.111038 (međunarodna recenzija, članak, znanstveni)


Naslov
Residual stress state in pipe cut ring specimens for fracture toughness testing

Autori
Damjanović, Darko ; Kozak, Dražan ; Marsoner, Stefan ; Gubeljak, Nenad

Izvornik
Materialprufung (0025-5300) 59 (2017); 530-535

Vrsta, podvrsta i kategorija rada
Radovi u časopisima, članak, znanstveni

Ključne riječi
Residual stress, pipe, incremental hole drilling method (IHDM), splitting method, X-ray diffraction (XRD), ring specimen, pipe ring notched bend specimen (PRNB)

Sažetak
Thin-walled pipes are not suitable for measuring fracture toughness parameters of vital importance because longitudinal crack failure is the most common failure mode in pipes. This is due to the impossibility to manufacture standard specimens for measuring fracture toughness, such as SENB or CT specimens, from the thin wall of the pipe. Previous works noticed this problem, but until now, a good and convenient solution has not been found or developed. To overcome this problem, very good alternative solution was proposed, the so- called pipe ring notched bend specimen (PRNB) [1-5]. Until now, only the idealized geometry PRNB specimen is analyzed, i. e., a specimen which is not cut out from an actual pipe but produced from steel plate. Based on that, residual stresses are neglected along with the imperfections in geometry (elliptical and eccentricity). The aim of this research is to estimate the residual stress state(s) in real pipes used in the boiler industry produced by hot rolling technique. These types of pipes are delivered only in normalized condition, but not stress relieved. Therefore, there are residual stresses present due to the manufacturing technique, but also due to uneven cooling after the production process. Within this paper, residual stresses are estimated by three methods: the incremental hole drilling method (IHMD), X-ray diffraction (XRD) and the splitting method (SM). Knowing the residual stress state in the ring specimen, it is possible to assess their impact on fracture toughness measured on the corresponding PRNB specimen(s).

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo



POVEZANOST RADA


Projekt / tema
152-1201910-1909 - Analiza i procjena loma konstrukcija iz anizotropnih materijala (Dražan Kozak, )

Ustanove
Strojarski fakultet, Slavonski Brod

Časopis indeksira:


  • Web of Science Core Collection (WoSCC)
    • Science Citation Index Expanded (SCI-EXP)
    • SCI-EXP, SSCI i/ili A&HCI
  • Scopus


Citati