Napredna pretraga

Pregled bibliografske jedinice broj: 729694

ACCURACY IN THE GEOMETRICAL CHARACTERISTICS REDUCTION METHOD OF STEP SHAFT AT DEFLECTION COMPUTING


Kotšmíd, Stanislav; Marienčík, Ján; Beňo, Pavel; Minárik, Marián; Kozak, Dražan; Konjatić, Pejo
ACCURACY IN THE GEOMETRICAL CHARACTERISTICS REDUCTION METHOD OF STEP SHAFT AT DEFLECTION COMPUTING // Proceedings of TEAM 2014 / Lóránt Kovács, Zsolt Csaba Johanyák, Róbert Pap-Szigeti (ur.).
Kecskemet: Kecskemét College, Faculty of Mechanical Engineering and Automation, 2014. str. 428-433 (predavanje, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)


Naslov
ACCURACY IN THE GEOMETRICAL CHARACTERISTICS REDUCTION METHOD OF STEP SHAFT AT DEFLECTION COMPUTING

Autori
Kotšmíd, Stanislav ; Marienčík, Ján ; Beňo, Pavel ; Minárik, Marián ; Kozak, Dražan ; Konjatić, Pejo

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
Proceedings of TEAM 2014 / Lóránt Kovács, Zsolt Csaba Johanyák, Róbert Pap-Szigeti - Kecskemet : Kecskemét College, Faculty of Mechanical Engineering and Automation, 2014, 428-433

ISBN
978-615-5192-22-7

Skup
6th International Scientific and Expert Conference of the International TEAM Society

Mjesto i datum
Kecskemet, Mađarska, 10-11.11.2014

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
Deformation; relative percentage errors; shaft deflection; step shaft

Sažetak
The contribution deals with the computing method of step shaft deflection in an intended place by using the diameter reduction method. This method is analytically studied on the selected shaft shape at different variants of diameters and individual span lengths, where values of deflection are compared with computed values without using of this reduction. These values were selected as exact, which was verified by numerical computing in PTC Creo Simulate software. In this contribution, the relative percentage errors are graphically interpreted, and it also deals with the creating of limiting conditions for its using. The aim is to point at limiting conditions of using this method, which may not be always met in practice. It also points to possible failures of this method, which is shown in an incorrect dimension of the shaft, influencing the reliability and safety of duty.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo



POVEZANOST RADA


Projekt / tema
152-1201910-1909 - Analiza i procjena loma konstrukcija iz anizotropnih materijala (Dražan Kozak, )

Ustanove
Strojarski fakultet, Slavonski Brod