engleski

Prints Recycling in Function of the Press Conditions and Substrate Characteristics

The directions of the ecological sustainability in printing reproduction are in the area of the application of the renewable and recycled raw materials, in the decrease of the energy consumption, the usage of the energy from the renewable sources and in the production without waste. This article presents the research results of voltage changes of the intermediate cylinder in indirect electrophotography with liquid toner on dirt count and area on handsheet made from fibers after prints pulping and flotation, brightness and effective residual ink concentration. Since on the indirect transfer of ElectroInk except the voltage of the intermediate cylinder also impacts temperature, its influence on the dirt count and area is showed. Uncoated and both side coated substrates were used for printing. The results show that changes in voltage of the intermediate cylinder in the printing affects the characteristics of pulped and floated fibers and dirt count and area on handsheets. Dominant factor of studied process is surface treatment of the printing substrate. Maximum efficiency of deinking flotation (87.7%) was observed on non coated paper print, at the voltage of the intermediate cylinder of 700 V. The efficiency of deinking flotation on both sides coated paper prints in dependence on the voltage of the intermediate cylinder in most cases is below 10%. The results show that an increase in temperature of the intermediate cylinder increases dirt count and area on handsheetst after pulping prints under experimental conditions. Increased efficiency of flotation was found for print obtained at a lower temperature of the intermediate cylinder.

Indirect electrofotography; ElectroInk transfer; Voltage; Temperature; Recycling; Image analysis; Brightness; ERIC

nije evidentirano