Napredna pretraga

Pregled bibliografske jedinice broj: 647238

ESTIMATION OF OVERHEAD TRANSMISSION LINE AEOLIAN VIBRATIONS


Wolf, Hinko; Semenski, Damir; Korošić, Saša
ESTIMATION OF OVERHEAD TRANSMISSION LINE AEOLIAN VIBRATIONS // Proceedings of 30th DANUBIA-ADRIA Symposium on Advances in Experimental Mechanics / Alfirević, Ivo ; Semenski, Damir (ur.).
Zagreb: CROATIAN SOCIETY OF MECHANICS, 2013. str. 252-253 (poster, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)


Naslov
ESTIMATION OF OVERHEAD TRANSMISSION LINE AEOLIAN VIBRATIONS

Autori
Wolf, Hinko ; Semenski, Damir ; Korošić, Saša

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
Proceedings of 30th DANUBIA-ADRIA Symposium on Advances in Experimental Mechanics / Alfirević, Ivo ; Semenski, Damir - Zagreb : CROATIAN SOCIETY OF MECHANICS, 2013, 252-253

ISBN
978-953-7539-17-7

Skup
30th DANUBIA-ADRIA Symposium on Advances in Experimental Mechanics

Mjesto i datum
Primošten, Croatia, 25-25. 09. 2013

Vrsta sudjelovanja
Poster

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
Aeolian vibrations; overhead transmission line; energy balance method; field measurements

Sažetak
Aeolian vibrations of overhead transmission line conductors are usually noticed at frequencies 5-100 Hz. These vibrations can cause the damage and breaking of the conductor due to material fatigue, and can significantly shorten its lifetime.Very large differences among the numerical results obtained by different computational programs are frequently observed. Two main reasons were identified for the large differences among the results. First, the aforementioned programs are based on several different models, i.e. different assumptions that are built into the models. Second, these programs use data from different sources that can differ significantly (wind power, data on the damper's mechanical impedance, mechanical characteristics of the conductor). Overhead transmission line Aeolian vibrations are in practice commonly estimated by using the Energy balance method (EBM) and the Modified energy balance method with using eigenfunctions (MEBM). In order to examine the accuracy of the developed computational programs, based on EBM and MEBM, as well as correctness of the estimation of the data used, results generated using the developed computer programs and data from field measurements using device VIBRECTM 400 are compared in this paper. A very high correlation between the measured field data and the data generated with the developed computer programs (EBM and MEBM) has been obtained.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo



POVEZANOST RADA


Projekt / tema
120-0362321-2198 - Numerička i eksperimentalna istraživanja nelinearnih mehaničkih sustava (Hinko Wolf, )

Ustanove
Fakultet strojarstva i brodogradnje, Zagreb