Dynamic analysis of CNC plasma cutting machine (CROSBI ID 582751)
Prilog sa skupa u zborniku | izvorni znanstveni rad | međunarodna recenzija
Podaci o odgovornosti
Baskaric, Tomislav ; Ergic, Todor ; Ivandic, Zeljko ; Kozak, Drazan ; Damjanovic, Darko
engleski
Dynamic analysis of CNC plasma cutting machine
This paper presents dynamic analysis of CNC plasma cutting machine. Deformations of machine parts that carry plasma torch directly affect on the quality of the technological process of machine. Displacements of the tip of plasma torch must be smaller than 0, 02 mm, which was one of the initial conditions that the machine must fulfill. Therefore, displacements of the tip of plasma torch for maximal feed rate acceleration and in the most unfavorable situation are calculated analytically and numerically (by Finite Element Method). Unwanted displacements of the plasma torch tip may occur due to resonance of certain machine parts. Therefore, the natural frequencies of some machine parts are calculated. On the existing construction were made the necessary measurements of dynamic values with the aim of identifying and proving the calculated results.
dynamic analysis; identification of linear dynamic system; damping; amplitude amplification
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
Podaci o prilogu
2011.
objavljeno
Podaci o matičnoj publikaciji
Vibration Problems ICOVP 2011 : Supplement, The 10th International Conference on Vibration Problems
Segl'a, tefan ; Tuma, Jirí ; Petríková, Iva ; Peek, Ludek ; Zapomel, Jaroslav ; Kruisová, Alena ; Gendelman, Oleg ; Berezovski, Arkadi ;
Liberec: Technical University of Liberec
978-80-7372-759-8
Podaci o skupu
International Conference on Vibration Problems 2011
poster
05.09.2011-08.09.2011
Prag, Češka Republika