Napredna pretraga

Pregled bibliografske jedinice broj: 545405

Flatness of Mechanical Interface of Housing Filter: Comparing Methods


Hodak, Marko; Barišić, Branimir; Katalinić, Branko; Kršulja, Marko; Car, Zlatan
Flatness of Mechanical Interface of Housing Filter: Comparing Methods // Annals of DAAAM for 2011 & Proceedings of the 22nd International DAAAM Symposium / Katalinić, Branko (ur.).
Vienna: DAAAM International, 2011. str. 1381-1382 (predavanje, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)


Naslov
Flatness of Mechanical Interface of Housing Filter: Comparing Methods

Autori
Hodak, Marko ; Barišić, Branimir ; Katalinić, Branko ; Kršulja, Marko ; Car, Zlatan

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
Annals of DAAAM for 2011 & Proceedings of the 22nd International DAAAM Symposium / Katalinić, Branko - Vienna : DAAAM International, 2011, 1381-1382

ISBN
978-3-901509-83-4

Skup
International DAAAM Symposium : Intelligent Manufacturing & Automation: Power of Knowledge and Creativity (22 ; 2011)

Mjesto i datum
Beč, Austrjia, 23.-26.11.2011

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
Flatness ; CMM ; Measurements ; Quality ; Methods
(Flatness ; CMM ; measurements ; quality ; methods)

Sažetak
This paper includes investigation of measuring methods for flatness on an aluminum housing filter produced with the procedure of casting. Several methods were taken in consideration for the flatness investigation. Comparison of measurements of flatness has been made, measured with CMM (Coordinate Measuring Machine), marble table and comparator. In this paper we can see that the method of the CMM is the most suitable for measurements in serial production. It can be the only right method for measuring of flatness. The maximum number of point’s necessary to achieve quality measurement is analyzed. For measurement purposes made in this paper are used the laboratories of production facilities of the “Cimos” company and laboratory of the Technical Faculty in Rijeka. The results and method are given for further flatness research for this specific part is presented.

Izvorni jezik
Engleski

Znanstvena područja
Metalurgija, Računarstvo, Strojarstvo



POVEZANOST RADA


Projekt / tema
069-1201787-1754 - Numeričko modeliranje, simulacija i optimizacija u oblikovanju lima (Zlatan Car, )

Ustanove
Tehnički fakultet, Rijeka