Some Considerations on a Molding Simulation for a Polyethylene Product (CROSBI ID 576266)
Prilog sa skupa u zborniku | izvorni znanstveni rad | međunarodna recenzija
Podaci o odgovornosti
Gregov, Goran ; Žic, Samir ; Kršulja, Marko ; Barišić, Branimir ; Kudlaček, Jan
engleski
Some Considerations on a Molding Simulation for a Polyethylene Product
A number of considerations must be taken into account while designing a plastic product. Use of simulations facilitates creation of defect free products while taking in consideration its final use. In this paper an investigation of filling time, cycle and considerations of design geometry, material flow, mold and product cooling are discussed. An example of a tap used as insert into chairs with tube frame is shown and its production analyzed. Cycle times are tested in real production and results discussed. Mold flow simulation is used for prediction and control of runner balancing.
injection molding; 3D design; polyethylene; mold; plastic
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
Podaci o prilogu
790-793.
2011.
objavljeno
Podaci o matičnoj publikaciji
International Conference on Innovative Technologies IN-TECH
Kudlaček, Jan ; Car, Zlatan ; Barišić, Branimir ; Pepelnjak, Tomaž ; Pakosta, Michal ; Kršulja, Marko
Prag: Tisk AS Jaroměř
978-80-904502-6-4
Podaci o skupu
International Conference on Innovative Technologies IN-TECH
predavanje
01.09.2011-03.09.2011
Bratislava, Slovačka