Analysis of cutting forces in turning of workpiece with a slot (CROSBI ID 573590)
Prilog sa skupa u zborniku | izvorni znanstveni rad | međunarodna recenzija
Podaci o odgovornosti
Baškarić, Tomislav ; Damjanović, Darko ; Duspara, Miroslav ; Kozak, Dražan ; Ergić, Todor ; Stoić, Antun
engleski
Analysis of cutting forces in turning of workpiece with a slot
Cutting forces in case of turning are analysed in this paper. In the first case, circular workpiece without the slot is analysed. Further, circular workpiece with a square slot is analysed. Obtained measurement results are compared with each other. Following processing parameters were varied: radial depth of cutting, cutting speed and feed rate. Analysis of cutting forces in case of turning the workpiece with a slot is analogous to the cutting forces in milling when the mill is in contact with the workpiece. Based on the measurement results, optimal processing parameters for turning the workpiece with a slot are determined.
Cutting forces in turning; the workpiece with a rectangular slot; cutting parameters
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
Podaci o prilogu
37-38.
2011.
objavljeno
Podaci o matičnoj publikaciji
10th Youth Symposium on Experimental Solid Mechanics
Martin Stockmann, Jens Kretzschmar
Chemnitz: Chemnitz University of Technology, Institute of Mechanics and Thermodynamics, Department of Solid Mechanics
978-3-941003-34-7
Podaci o skupu
10th Youth Symposium on Experimental Solid Mechanics
predavanje
25.05.2011-28.05.2011
Chemnitz, Njemačka