Nalazite se na CroRIS probnoj okolini. Ovdje evidentirani podaci neće biti pohranjeni u Informacijskom sustavu znanosti RH. Ako je ovo greška, CroRIS produkcijskoj okolini moguće je pristupi putem poveznice www.croris.hr
izvor podataka: crosbi !

IMPACT OF ABRASIVE MASS FLOW RATE WHEN PENETRATING INTO A MATERIAL ON ITS VIBRATION (CROSBI ID 168378)

Prilog u časopisu | prethodno priopćenje

Hreha, Pavol ; Hloch, Sergej ; Valíček, Jan ; Monková, Katarína ; Monka, Peter ; Harničárová, Marta ; Fusek, Martin ; Konjatić, Pejo IMPACT OF ABRASIVE MASS FLOW RATE WHEN PENETRATING INTO A MATERIAL ON ITS VIBRATION // Tehnički vjesnik : znanstveno-stručni časopis tehničkih fakulteta Sveučilišta u Osijeku, 17 (2010), 4; 475-480

Podaci o odgovornosti

Hreha, Pavol ; Hloch, Sergej ; Valíček, Jan ; Monková, Katarína ; Monka, Peter ; Harničárová, Marta ; Fusek, Martin ; Konjatić, Pejo

engleski

IMPACT OF ABRASIVE MASS FLOW RATE WHEN PENETRATING INTO A MATERIAL ON ITS VIBRATION

The article deals with the impact of mass flow rate of abrasive in a water jet when penetrating into a material by using the vibration analysis. The vibrations of material were recorded by sensors placed on the experimental material. Values that were studied were amplitude and FFT (Fast FourierTransform) spectrum of signal. The stainless steel AISI309 was used as the experimental material. Data recorded during the cutting process of theAWJ cutting were analysed by the LabVIEWprogramming environment. The paper outlines the course of the recorded data and the FFTspectrum of this signal. Presented here is only a part of the basic research focused on the application of vibrations as a feedback for on-line control of abrasive water jet.

abrasive water jet; abrasive mass flow rate; penetration into material; vibration analysis

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

Podaci o izdanju

17 (4)

2010.

475-480

objavljeno

1330-3651

Povezanost rada

Strojarstvo

Indeksiranost