BUILT-UP MATERIAL IN MACHINING OF LIGHT METALS (CROSBI ID 348865)
Ocjenski rad | doktorska disertacija
Podaci o odgovornosti
Tomac, Nikola
Rasch, Finn Ola
engleski
BUILT-UP MATERIAL IN MACHINING OF LIGHT METALS
When magnesium alloys are machined with carbide tools at high cutting speed, workpiece material may build-up on the tool, accompanied by a sharp increase in surface roughness and tool forces. It was shown through cutting experiments that with the use of a water based cutting fluid the flank build-up problems were completely eliminated within the actual cutting speed range. A part of this work shows that magnesium alloys can be machined with the polycristalline diamond (PCD) tool at very high cutting speeds without the FBU formation and with less fire hazard.
Production Engineering; Machining; Magnesium
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
Podaci o izdanju
160
05.10.1993.
obranjeno
Podaci o ustanovi koja je dodijelila akademski stupanj
Trondheim, Norway