Nalazite se na CroRIS probnoj okolini. Ovdje evidentirani podaci neće biti pohranjeni u Informacijskom sustavu znanosti RH. Ako je ovo greška, CroRIS produkcijskoj okolini moguće je pristupi putem poveznice www.croris.hr
izvor podataka: crosbi !

Power requirements during planing and surface quality of planed elements (CROSBI ID 529761)

Prilog sa skupa u zborniku | izvorni znanstveni rad | međunarodna recenzija

Beljo Lučić, Ružica ; Čavlović, Ankica ; Ištvanić, Josip ; Đukić, Igor ; Mihulja, Goran Power requirements during planing and surface quality of planed elements // Proceedings of the 2nd International Scientific Conference Woodworking Techniques / Goglia, Vlado ; Barcik, Štefan (ur.). Zagreb: Fakultet strojarstva i brodogradnje Sveučilišta u Zagrebu, 2007. str. 215-220

Podaci o odgovornosti

Beljo Lučić, Ružica ; Čavlović, Ankica ; Ištvanić, Josip ; Đukić, Igor ; Mihulja, Goran

engleski

Power requirements during planing and surface quality of planed elements

This paper presents the results of research on power requirements, noise emission and surface quality during planing of solid walnut-wood (Juglans regia L.), cherry-wood (Prunus avium L.) and horse chestnut-wood (Castanea sativa Mill.). The variables concerned were: feed rate, cutting depth and cutting directions with regard to grain directions. The cutting speed and tool parameters were constant. Cutting power reaches higher values during planing with grater feed speed and greater cutting depth. Results have shown that the power requirements are lower when planing radial board than tangential and semi-radial boards, especially when the cutting depth is greater. The level of noise emission could be expressed in dependence on power requirements. The best surface quality is measured with cherry-wood planed elements. There are no significant changes in surface quality under the influence of cutting depth and different feed speed in the experiment.

walnut-wood; cherry-wood; horse chestnut-wood; planing; power requirements; surface quality

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

Podaci o prilogu

215-220.

2007.

objavljeno

Podaci o matičnoj publikaciji

Proceedings of the 2nd International Scientific Conference Woodworking Techniques

Goglia, Vlado ; Barcik, Štefan

Zagreb: Fakultet strojarstva i brodogradnje Sveučilišta u Zagrebu

953-6307-94-4

Podaci o skupu

International Scientific Conference (2 ; 2007)

predavanje

11.09.2007-15.09.2007

Zalesina, Hrvatska

Povezanost rada

Šumarstvo