Nalazite se na CroRIS probnoj okolini. Ovdje evidentirani podaci neće biti pohranjeni u Informacijskom sustavu znanosti RH. Ako je ovo greška, CroRIS produkcijskoj okolini moguće je pristupi putem poveznice www.croris.hr
izvor podataka: crosbi

Improvements in Thermo Reactive Deposition of Carbide Layers (CROSBI ID 129569)

Prilog u časopisu | izvorni znanstveni rad | međunarodna recenzija

Matijević, Božidar ; Stupnišek, Mladen Improvements in Thermo Reactive Deposition of Carbide Layers // Surface engineering, 23 (2007), 1; 1-4

Podaci o odgovornosti

Matijević, Božidar ; Stupnišek, Mladen

engleski

Improvements in Thermo Reactive Deposition of Carbide Layers

This paper presents developments contributing to the improvement of the process of producing hard carbide layers, with special attention to the application on tools and dies. The quantitative impact of the chemical composition of the steel and the process temperature on the kinetics of the carbide layer formation has been determined. In conventional processes of diffusion formation of carbide layers the phenomenon of partial de-carburization of steel occurring beneath the carbide layer during the process of its formation has been dealt with by the introduction of controlled pre-carburization. Diffusion formation of carbide layers has been improved by the development of duplex processes that enable the formation of a case hardened layer which is harder than the core. Thus, the substrate for the hard and brittle carbide layer is improved. This development should contribute to the improvement of properties of the surface layers produced by the diffusion formation of carbide layers. In this way this process can be applied to the manufacturing of tools and dies.

diffusion; carbide layer; vVanadium carbide; duplex treatment; carburising; decarburizing; case hardened layer; tools; dies

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

Podaci o izdanju

23 (1)

2007.

1-4

objavljeno

0267-0844

Povezanost rada

Metalurgija, Strojarstvo