Nalazite se na CroRIS probnoj okolini. Ovdje evidentirani podaci neće biti pohranjeni u Informacijskom sustavu znanosti RH. Ako je ovo greška, CroRIS produkcijskoj okolini moguće je pristupi putem poveznice www.croris.hr
izvor podataka: crosbi

The Influence of Surface Roughness on Load Bearing Capacity of Adhesive Joints (CROSBI ID 507144)

Prilog sa skupa u zborniku | izvorni znanstveni rad | međunarodna recenzija

Raos, Pero ; Stoić, Antun ; Lucić, Mirjana The Influence of Surface Roughness on Load Bearing Capacity of Adhesive Joints // Proceedings of the 10th Internatonal Scientific Conference on Production Engineering / Cebalo, Roko ; Schulz, Herbert (ur.). Zagreb: Hrvatska udruga proizvodnog strojarstva (HUPS), 2005. str. IV-91-IV-102-x

Podaci o odgovornosti

Raos, Pero ; Stoić, Antun ; Lucić, Mirjana

engleski

The Influence of Surface Roughness on Load Bearing Capacity of Adhesive Joints

Experimental results on the effect of surface roughness on the adhesive joint strength have been presented in this paper. Mechanical properties of single lap adhesive joints with different surface roughness were tested and examined. Testing joints were made using two types of adherends: aluminium and stainless steel ; and one type of adhesive: two component high-strength engineering adhesive. Good correlation was found between the theoretical knowledge and experimental results. It was also found that treating surfaces of soft materials like aluminium are significant different than treating materials like stainless steel, by means of surface roughness, because higher roughness diverse range could be reached.

surface roughness; adhesive bonding; single-lap joints

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

Podaci o prilogu

IV-91-IV-102-x.

2005.

objavljeno

Podaci o matičnoj publikaciji

Proceedings of the 10th Internatonal Scientific Conference on Production Engineering

Cebalo, Roko ; Schulz, Herbert

Zagreb: Hrvatska udruga proizvodnog strojarstva (HUPS)

Podaci o skupu

Computer Integrated Manufacturing and High Speed Machining CIM 2005

predavanje

15.06.2005-17.06.2005

Korčula, Hrvatska; Lumbarda, Hrvatska

Povezanost rada

Strojarstvo