Nalazite se na CroRIS probnoj okolini. Ovdje evidentirani podaci neće biti pohranjeni u Informacijskom sustavu znanosti RH. Ako je ovo greška, CroRIS produkcijskoj okolini moguće je pristupi putem poveznice www.croris.hr
izvor podataka: crosbi

Semi-automatic determination of the parallelism of rollers in the aluminium factory TLM-Šibenik (CROSBI ID 106522)

Prilog u časopisu | izvorni znanstveni rad | međunarodna recenzija

Solarić, Nikola ; Veršić, Zoran ; Barković, Đuro Semi-automatic determination of the parallelism of rollers in the aluminium factory TLM-Šibenik // Survey review - Directorate of Overseas Surveys, 37 (2004), 293; 577-588-x

Podaci o odgovornosti

Solarić, Nikola ; Veršić, Zoran ; Barković, Đuro

engleski

Semi-automatic determination of the parallelism of rollers in the aluminium factory TLM-Šibenik

The paper describes the semi-automatic determination of the parallelism of rollers in factory engine rooms by means of an electronic theodolite Kern E2 (0.5 arc sec) and notebook computers. A priori standard deviations in determining the parallelism of rollers have been carried out with the theodolite from 2 to 15 m away from the 1 m to 4 m long rollers and the standard deviation of distance measurement from 1 mm to 5 mm. Apart from that, it has been established that the optimum distances between the theodolite and the roller are as follows: - approximately 2 m, if the distances are measured with a standard deviation of 1 mm, and - approximately 4 m, if the distances are measured with a standard deviation of 5 mm. In the aluminium factory TLM in Šibenik (Croatia), the precision obtained in determining the parallelism of rollers runs up to 0.03 mm/m in real factory conditions, and the method has shown to be very practical.

Semi-automatic measurement

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

Podaci o izdanju

37 (293)

2004.

577-588-x

objavljeno

0039-6265

Povezanost rada

Geodezija

Indeksiranost