Napredna pretraga

Pregled bibliografske jedinice broj: 139346

Identification of cutting conditions in turning by noise recording


Raos, Pero; Stoić, Antun; Kopač, Janez
Identification of cutting conditions in turning by noise recording // Tehnički vjesnik Znanstveno stručni časopis tehničkih fakulteta Sveučilišta u Osijeku, 10 (2003), 2; 11-16 (međunarodna recenzija, članak, znanstveni)


Naslov
Identification of cutting conditions in turning by noise recording

Autori
Raos, Pero ; Stoić, Antun ; Kopač, Janez

Izvornik
Tehnički vjesnik Znanstveno stručni časopis tehničkih fakulteta Sveučilišta u Osijeku (1330-3651) 10 (2003), 2; 11-16

Vrsta, podvrsta i kategorija rada
Radovi u časopisima, članak, znanstveni

Ključne riječi
Turning parameters; monitoring; noise

Sažetak
The aim of investigations was acquisition of sound pressure signal that appears near the cutting zone during the turning process. It was assumed and confirmed that acquisition of noise signals has its advantages and limitations. The measurements were performed on a heat treatable steel Č1431, whereas CBN inserts were used during dry cutting. Noise and acceleration data were recorded and analysed in frequency range between 1 to 20 kHz. An influence of cutting speed, insert radius and tool wear on signals was observed. The results showed that a high possibility in terms of process monitoring exists for both groups of signals, especially for a large-scale production.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo



POVEZANOST RADA


Projekt / tema
0152011

Ustanove
Strojarski fakultet, Slavonski Brod

Autor s matičnim brojem:
Pero Raos, (121221)
Antun Stoić, (190286)

Časopis indeksira:


  • Scopus


Uključenost u ostale bibliografske baze podataka:


  • The INSPEC Science Abstracts series