Shrinkage porosity in thin walls of steel castings (CROSBI ID 735681)
Prilog sa skupa u zborniku | sažetak izlaganja sa skupa | međunarodna recenzija
Podaci o odgovornosti
Usenko, R. V. ; Mamuzić, Ilija ; Mazorchuk, V. F.
engleski
Shrinkage porosity in thin walls of steel castings
The reason for the occurrence of shrinkage porosity in the walls of steel castings with a thickness of 1 ... 5 mm is the uneven thickness of the layer of solidified steel melt on the mold surface. The uneven thickness of this layer is due to the variability of the melt flow rate in a thin wall during mold casting. To prevent the appearance of shrinkage porosity, the casting of the mold should be carried out at high speed and with increased overheating of the poured steel melt.
steel castings ; shrinkage porosity ; uneven thickness
The conference was canceled due the low number of presenters registered for the conference, but the Book of abstracts has been published.
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
Podaci o prilogu
493-493.
2023.
objavljeno
Podaci o matičnoj publikaciji
Supplement of the Book of abstracts of the 16th International Symposium of Croatian Metallurgical Society - SHMD '2023, Materials and metallurgy (published in: Metalurgija 62 (2023) 3-4)
Mamuzić, Ilija
Zagreb:
Podaci o skupu
16th International Symposium of Croatian Metallurgical Society - SHMD '2023, Materials and metallurgy
poster
20.04.2023-21.04.2023
Zagreb, Hrvatska