Napredna pretraga

Pregled bibliografske jedinice broj: 126101

Application of the Milling Machine Vibration Signal for Cutter Condition Monitoring


Hnatko, Emil; Majdandžić, Niko; Ergić, Todor; Stoić, Antun; Šarić, Tomislav; Jozić, Marko; Tadijanović, Adam
Application of the Milling Machine Vibration Signal for Cutter Condition Monitoring // Proceedings of the 1st DAAAM International Conference, Advanced Technologies for Developing Countries, ATDC'02 / Katalinić, Branko ; Kljajin, Milan (ur.). (ur.).
Osijek : Grafika: DAAAM International Vienna& Mech. eng. Faculty Slav. Brod & Grafika Osijek, 2002. str. 483-488 (predavanje, međunarodna recenzija, cjeloviti rad (in extenso), pregledni)


Naslov
Application of the Milling Machine Vibration Signal for Cutter Condition Monitoring

Autori
Hnatko, Emil ; Majdandžić, Niko ; Ergić, Todor ; Stoić, Antun ; Šarić, Tomislav ; Jozić, Marko ; Tadijanović, Adam

Vrsta, podvrsta i kategorija rada
Sažeci sa skupova, cjeloviti rad (in extenso), pregledni

Izvornik
Proceedings of the 1st DAAAM International Conference, Advanced Technologies for Developing Countries, ATDC'02 / Katalinić, Branko ; Kljajin, Milan (ur.). - Osijek : Grafika : DAAAM International Vienna& Mech. eng. Faculty Slav. Brod & Grafika Osijek, 2002, 483-488

Skup
1st DAAAM International Conference, Advanced Technologies for Developing Countries, ATDC'02

Mjesto i datum
Slavonski Brod, Hrvatska, 12-14.09.2002.

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
Vibration Signal; Tool Wear; Milling Machine; Measurement

Sažetak
As a continuing effort in researching the influence of the working milling machine parameters on the vibration, a new series of measurements were conducted using experiences from the previous measurements. In order to keep the results comparable to the previous ones some of the working parameters were kept the same , eg. tool geometry, cutting speed, material and geometry of the workpiece. This time an important part of the research was tool wear during the work of the milling machine. The acceleration was used as the vibration signal and it was monitored booth as a function of time and as a function of frequency.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo



POVEZANOST RADA