Nalazite se na CroRIS probnoj okolini. Ovdje evidentirani podaci neće biti pohranjeni u Informacijskom sustavu znanosti RH. Ako je ovo greška, CroRIS produkcijskoj okolini moguće je pristupi putem poveznice www.croris.hr
izvor podataka: crosbi

Reusing waste coffee grounds in the preparation of porous alumina ceramics (CROSBI ID 315891)

Prilog u časopisu | izvorni znanstveni rad | međunarodna recenzija

Kerolli Mustafa, Mihone ; Gabelica, Ivana ; Mandić, Vilko ; Veseli, Rea ; Ćurković, Lidija Reusing waste coffee grounds in the preparation of porous alumina ceramics // Sustainability, 14 (2022), 21; 14244, 13. doi: 10.3390/su142114244

Podaci o odgovornosti

Kerolli Mustafa, Mihone ; Gabelica, Ivana ; Mandić, Vilko ; Veseli, Rea ; Ćurković, Lidija

engleski

Reusing waste coffee grounds in the preparation of porous alumina ceramics

Porous ceramics can be used in various industrial applications, such as thermal insulation, orthopedic implants, high-temperature filtration, lightweight structural components, and catalyst supports, etc., and can be obtained using various methods. In this study, the sacrificial fugitive method was used to prepare a porous alumina ceramic. The appropriate amount of sacrificial fugitive was combined with raw ceramic powder as a pore-forming agent, and was then evaporated or burned out either before or during the sintering process to create the desired pores. Various materials can be used as pore-forming agents ; in this work, eco-friendly waste coffee grounds (WCG) were utilized. First, alumina ceramic green bodies were prepared via slip casting of 60 wt. % alumina suspensions with five different amounts of WCG (0 wt. %, 1 wt. %, 5 wt. %, 10 wt. % and 15 wt. %) and the dispersant Dolapix (0.2 wt. %), and using PVA (0.5 wt. %) as a binder for all solutions. The effect of the various amounts of WCG on the alumina ceramic green bodies, and subsequently on the obtained sintered ceramics, was tracked and validated through different analyses. Suspension viscosity was determined through a rotational viscometer. Simultaneous differential thermal and thermogravimetric (DTA/TGA) analyses were used to observe the thermal decomposition of WCG and to determine the sintering regime. After sintering, the density, porosity, and shrinkage of the samples were examined and calculated. In addition, the phase composition and crystallite size of all sintered samples were determined by powder X-ray diffraction (PXRD) analysis, as well as their morphology and composition using Scanning Electron Microscopy (SEM) equipped with energy dispersive X-ray spectroscopy (EDS). The results show that density decreased from 3.743 to 2.172 g/cm3 and porosity increased from 6.12% to 45.52%, both with the increasing amount of WCG (from 0 wt. % to 15 wt. %).

porous ceramics ; alumina ; waste coffee

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

Podaci o izdanju

14 (21)

2022.

14244

13

objavljeno

2071-1050

10.3390/su142114244

Povezanost rada

Kemijsko inženjerstvo, Strojarstvo, Temeljne tehničke znanosti

Poveznice
Indeksiranost