Measuring setdown output parameter of cross-wire welded mesh with reconfigurable measuring system (CROSBI ID 724434)
Prilog sa skupa u zborniku | stručni rad | međunarodna recenzija
Podaci o odgovornosti
Vlatković, Maja ; Čabrijan, Ivana ; Pavletić, Duško ; Doboviček, Sandro
engleski
Measuring setdown output parameter of cross-wire welded mesh with reconfigurable measuring system
This paper describes setdown output parameter dimension measuring procedure for the wire mesh obtained by the cross-wire welding process. The measurement is performed by non-contact reconfigurable measurement system enhanced with a machine vision. Advantage of this kind of a system are found in a fact that, apart from the necessary dimensions, also images of the welds are obtained, saved and used for further analysis of the parameters influence on the final weld appearance. The analysis of the measuring system is shown in the paper in order to confirm that the measuring system is acceptable, also the measurement results are compared with ones obtained by conventional method. Analysis of the measurement system also shows that the change of measuring operator has no influence on the obtained measurements. Measurements of the setdown dimensions are shown in the results section of the paper and it was determined that some measurements exceed the control limits.
Setdown ; Cross-wire welding ; Wire mesh ; Reconfigurable measuring system ; Machine vision ; Quality control
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
Podaci o prilogu
169-174.
2022.
objavljeno
Podaci o matičnoj publikaciji
"Mechanical Technologies and Structural Materials 2022"
Jozić, Sonja ; Lela, Branimir ; Gjeldum, Nikola
Split: Hrvatsko društvo za zaštitu materijala (HDZaMa)
1847-7917
Podaci o skupu
11th International Conference Mechanical Technologies and Structural Materials (MTSM 2022)
poster
22.09.2022-23.09.2022
Split, Hrvatska