Monitoring of Cutting Process by Measuring of Cutting Forces and Momentum (CROSBI ID 466012)
Prilog sa skupa u zborniku | sažetak izlaganja sa skupa | međunarodna recenzija
Podaci o odgovornosti
Cebalo, Roko ; Goja, Željko ; Udiljak, Toma
engleski
Monitoring of Cutting Process by Measuring of Cutting Forces and Momentum
This paper presents the possibility for measuring technological parameters at high speed machining. A sensor, based on tenzometric principle, for measuring of axial force and momentum has been developed. The sensor is incorporated in workpiece clamping device. Processing of results measured at different cutting parameters enables the estimation of full range of loads that motorspindle is subjected during actual machining. The paper also analysis the significance of measured data for selection of bearing type, same as calculation of bearing, stiffness and vibration of motorspindle.
high-speed machining; cutting parameters; motorspidle
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
Podaci o prilogu
51-52-x.
1997.
objavljeno
Podaci o matičnoj publikaciji
Proceedings of the 8th International DAAAM Symposium
Katalinić, Branko
DAAAM International Vienna
Podaci o skupu
The 8th International DAAAM Symposium
predavanje
23.10.1997-25.10.1997
Dubrovnik, Hrvatska