Naslov
ANALYSIS OF 3D PRINTED NOTCHED SPECIMENS

Autori
Zsebe, Tomas ; Ferenc, Gyula ; Ferenc Orban, Vasvari ; Dako, Franjo ; Grizelj, Branko ; Samardzic, Ivan

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
11. INTERNATIONAL SCIENTIFIC-PROFESSIONAL CONFERENCE SBW 2021 „ENGINEERING TECHNOLOGIES IN MANUFACTURING OF WELDED CONSTRUCTIONS AND PRODUCTS, SBW 2021“ / Samardžić, Ivan ; Duspara, Miroslav ; Marić, Dejan - Slavonski Brod : University of Slavonski Brod, Mechanical Engineering Faculty in Slavonski Brod, 2021, 5-9

Skup
11th International Scientific-Professional Conference SBW 2021 "Engineering Technologies in Manufacturing of Welded Constructions and Products, SBW 2021" = 11. Međunarodno znanstveno-stručno savjetovanje "Strojarske tehnologije u izradi zavarenih konstrukcija i proizvoda, SBZ 2021."

Mjesto i datum
Slavonski Brod, Hrvatska, 03.11.2021. - 05.11.2021

Vrsta sudjelovanja
Poster

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
3D metal printing, three-point bending test, CMT, FEM analysis, notched specimen, WAAM

Sažetak
The base material of 3D printing is basically metal powder but in some researches wire form can also be applied. In this article the three-point bending test of specimens prepared with 3D printing is presented. These specimens were made with 2 different notches. The results of the tests were compared with the specimens which were crafted from a plate. The comparison shows there is no significant deviation between the results of the printed and the cut specimens. The effect of the notch was simulated by FEM. The results of the three-point bending test were compared with those of the FEM.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo

POVEZANOST RADA