Application FEM in plate bending (CROSBI ID 490103)
Prilog sa skupa u zborniku | izvorni znanstveni rad | međunarodna recenzija
Podaci o odgovornosti
Grizelj, Branko ;
engleski
Application FEM in plate bending
The paper is concerned with the numeric procedure in axial-symmetrical plate bending. For numeric procedure the finite element method is used. Calibration force is determined when bending force and calibration coefficient are known. The calibration coefficient is determined by experiment. The axial-symmetrical plate bending analysis is restricted to the data used so far in the manufacture of spherical tanks i.e. to deform. up to 1%. To obtain equations for the calculation of force for axial-symmetrical plate bending and displacements during loading procedure and after its removal, data obtained by finite element method were used. The method of least squares was used to interpolate results. Mathematical procedures were used to obtain equations for the calculation of force and displacements, the equations being of use for solving practical problems.
Axial-symmetrical bending; Finite element method; Calibration of plate
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
Podaci o prilogu
125-130-x.
2004.
objavljeno
Podaci o matičnoj publikaciji
Proceedings of the 3rd DAAAM International Conference on Advanced Technologies for Developing Countries
Branko, Katalinić ; Ivica, Veža, Boženko, Bilić
Split: University of Split, DAAAM International Vienna
Podaci o skupu
3rd DAAAM International Conference on Advanced Technologies for Developing Countries
predavanje
23.06.2004-26.06.2004
Trogir, Hrvatska