Napredna pretraga

Pregled bibliografske jedinice broj: 115611

Precision bending in two stages


Grizelj, Branko; Grizelj, Dejan; Kenter, Muhlis. I
Precision bending in two stages // Annals of DAAAM for 2003 & Proceedings of the 14th International DAAAM Symposium "Intelligent Manufacturing and Automation: Focus on Reconstruction and Development" / Branko, Katalinić ; (ur.).
Sarajevo, BiH: DAAAM International, Vienna, Austria, 2003. str. 171-172 (predavanje, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)


Naslov
Precision bending in two stages

Autori
Grizelj, Branko ; Grizelj, Dejan ; Kenter, Muhlis. I

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
Annals of DAAAM for 2003 & Proceedings of the 14th International DAAAM Symposium "Intelligent Manufacturing and Automation: Focus on Reconstruction and Development" / Branko, Katalinić ; - Sarajevo, BiH : DAAAM International, Vienna, Austria, 2003, 171-172

Skup
14th International DAAAM Symposium "Intelligent Manufacturing and Automation: Focus on Reconstruction and Development"

Mjesto i datum
Sarajevo, BiH, 22-25.10.2003

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
Bending; tool; part geometry; bending in two stages

Sažetak
Abstract: In manufacturing of working parts by metal forming there are a number of various methods, owing to sorts and largeness of parts as well as the demands for form and accuracy that cause different procedures and ways of bending process .Elastic part of deformation causes aberration of form and accuracy in bending. The important criterion in validation of bended parts presents the aberration of bending angle. As a measure for angle accuracy, it can be taken into account a relative error of bending angle. For the improvement of accuracy it is used a model, that compensate the mechanical spring back. The influence of mechanical spring back on bending angle can be eliminated, if it is in certain range of opposite direction and the same amount. The following elements exter influence on bending: press-brak, die, and work piece geometry. This paper analysis the influence precision bending in two stages.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo



POVEZANOST RADA


Projekt / tema
0152012

Autor s matičnim brojem:
Branko Grizelj, (18873)