Increasing wear resistance of steel rings for sliding bearings by surface engineering procedures (CROSBI ID 708653)
Prilog sa skupa u zborniku | izvorni znanstveni rad | međunarodna recenzija
Podaci o odgovornosti
Landek, Darko ; Zhao, Linruo ; Yang, Qi ; Dadouche, Azzedine
engleski
Increasing wear resistance of steel rings for sliding bearings by surface engineering procedures
The paper compares the possibilities of increasing the wear resistance of the sliding surface of steel rings EN DIN 100Cr6 (ASTM 52100) by nitriding processes in plasma and by coating processes from the vapor phase, PVD and PACVD. On the nitrated and coated bearing rings, the surface roughness was measured, the thickness and adhesion of the coatings were determined, and the friction coefficient and adhesion wear were tested by the sliding method “Block on Ring” Based on the test results for highly loaded sliding surfaces, the use of PACVD TiCN / TiN and PVD TiN coatings with good wear resistance and dry friction coefficient less than 0.1 is recommended.
sliding bearing, friction factor, salt bath nitriding, plasma nitriding, PVD, PACVD
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
Podaci o prilogu
314-325.
2021.
objavljeno
Podaci o matičnoj publikaciji
Proceedings of the 21th International Conference on Materials, Tribology and Recycling
Ćorić, Danko ; Šolić, Sanja ; Ivušić, Franjo
Varaždin: Hrvatsko društvo za materijale i tribologiju (HDMT)
2459-5608
Podaci o skupu
21th International Conference on Materials (MATRIB 2021)
predavanje
30.06.2021-02.07.2021
Vela Luka, Hrvatska