Nalazite se na CroRIS probnoj okolini. Ovdje evidentirani podaci neće biti pohranjeni u Informacijskom sustavu znanosti RH. Ako je ovo greška, CroRIS produkcijskoj okolini moguće je pristupi putem poveznice www.croris.hr
izvor podataka: crosbi

Kinetic study and optimization on SNCR process in pressurized oxy-combustion (CROSBI ID 284207)

Prilog u časopisu | izvorni znanstveni rad | međunarodna recenzija

Rahman, Zia ur ; Wang, Xuebin ; Zhang, Jiaye ; Baleta, Jakov ; Vujanović, Milan ; Tan, Houzhang Kinetic study and optimization on SNCR process in pressurized oxy-combustion // Journal of the energy institute, 94 (2021), 263, 271. doi: 10.1016/j.joei.2020.09.010

Podaci o odgovornosti

Rahman, Zia ur ; Wang, Xuebin ; Zhang, Jiaye ; Baleta, Jakov ; Vujanović, Milan ; Tan, Houzhang

engleski

Kinetic study and optimization on SNCR process in pressurized oxy-combustion

Pressurized Oxy-combustion is one of the most promising technologies for carbon capture, utilization, and storage (CCUS) of coal utilization. In pressurized oxy-combustion, the removal of acid gas pollutants and the latent heat of moisture condensation are mainly carried out by an integrated direct-contact wash column (DCC). Recent studies have shown that the inlet concentration of NOx in the column is important for the combined removal of NOx and SOx, therefore, it is essential to control the NOx emissions before the DCC. Selective non-catalytic reduction (SNCR) is a promising and economical technology of NOx reduction ; however, no study has been conducted on SNCR at elevated pressure, especially in pressurized oxy-combustion. In this paper, kinetic modeling is carried out to explore and optimize the NOx reduction by SNCR in pressurized oxy-combustion. First, the detailed mechanism used in this study is validated by the experimental results in literature. Based on the validation of the detailed mechanism, the effects of different parameters including temperature, oxygen concentration, moisture content, NH3 concentration, and SO2 concentrations on the SNCR performance are analyzed at higher pressures in oxy-combustion atmosphere. The modeling results show that by increasing the pressure from 1 atm to 15 atm, the SNCR de-NOx efficiency increased by 2e3%. The width of the optimum temperature window for maximum De-NOx is broadened from 1250K to 1450K with increasing the pressure from 1 atm to 10 atm. The increase of pressure has no significant effect on thermal de-NOx efficiency with increasing the NH3/ NO ratio. At higher pressure (10 atm) the increase in O2 concentration from 1 to 20% the de-NOx efficiency decreases almost twice as much as at 1 atm. The increase of SO2 and moisture contents at high pressure have no significant effect on the de-NOx efficiency. Rate of production (ROP) and sensitivity analysis are performed to determine the dominant reaction paths of de-NOx in pressurized-oxy SNCR process. This study can provide guidance for the process optimization of de-NOx by SNCR in pressurized oxy- combustion.

Pressurized oxy-combustion ; SNCR ; Chemkin ; Ammonia ; Rate of production

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

Podaci o izdanju

94

2021.

263

271

objavljeno

1743-9671

1746-0220

10.1016/j.joei.2020.09.010

Povezanost rada

Metalurgija, Strojarstvo

Poveznice
Indeksiranost