Napredna pretraga

Pregled bibliografske jedinice broj: 106259

Comparison Between Analytical and Numerical Mould Calculation fror Injection Moulding of Thermoplastics


Godec, Damir; Rot, Matjaž; Čatić, Igor
Comparison Between Analytical and Numerical Mould Calculation fror Injection Moulding of Thermoplastics // Conference Proceedings / Kuzman, Karl (ur.).
Celje: TECOS, 2001. str. 163-168 (predavanje, međunarodna recenzija, cjeloviti rad (in extenso), znanstveni)


Naslov
Comparison Between Analytical and Numerical Mould Calculation fror Injection Moulding of Thermoplastics

Autori
Godec, Damir ; Rot, Matjaž ; Čatić, Igor

Vrsta, podvrsta i kategorija rada
Radovi u zbornicima skupova, cjeloviti rad (in extenso), znanstveni

Izvornik
Conference Proceedings / Kuzman, Karl - Celje : TECOS, 2001, 163-168

Skup
ICIT 2001

Mjesto i datum
Rogaška Slatina, Slovenija, 24-26.04.2001

Vrsta sudjelovanja
Predavanje

Vrsta recenzije
Međunarodna recenzija

Ključne riječi
Injection Moulding; Mould; Analytical Calculation; Numerical Calculation

Sažetak
Special attention needs to be paid to the development of mould as the most important element of the system for injection moulding of thermoplastics. The central phase of mould development consists of the rheological, thermal and mechanical mould calculations which may be performed analytically and numerically. The numerical mould calculation applies computer simulation of single injection moulding cycle phases. With computer simulation it is possible to foresee the difficulties that might occur during the injection moulding. Although both approaches carry certain advantages and disadvantages, the increased complexity of thermoplastics mouldings gives growing importance to numerical calculations. On the other hand, analytical calculations are easier to use and the mould designer does not require any special training. Therefore, there is a need to compare these two approaches to mould calculation, and to indicate the advantages and the disadvantages of using either one of the calculations in certain mould calculation phases.

Izvorni jezik
Engleski

Znanstvena područja
Strojarstvo



POVEZANOST RADA


Projekt / tema
120036

Ustanove
Fakultet strojarstva i brodogradnje, Zagreb

Autor s matičnim brojem:
Damir Godec, (210751)
Igor Čatić, (7792)